|Processing Type:||Centrifugal Casting||Lead Time:||According To Required Time|
|QC Control:||100% Inspect By Us ,accept The Third Party Inspect||Feature:||Anti-erosion,Anti-abrasion,Load Capacity|
|Item:||Copper Slide Block||Size:||Non-standard Customization|
perforated copper plate,
polished copper sheet
High Load Linear Guide Rail Easy To Install Maintenance Free CE Certificated
Guide rail, also known as slide rail, linear guide rail and linear slide rail, is used in the situation of linear reciprocating motion. It has higher load rating than linear bearing and can bear certain torque at the same time. It can achieve high-precision straight-line movement under high load conditions. It can bear, fix, guide and reduce friction in mobile devices or devices. Longitudinal groove or edge on the surface of guide rail, used to guide and fix mechanical parts, special equipment, instruments, etc.
1. It has high hardness, excellent wear resistance, not easy to cause occlusion, good casting performance and cutting performance, and good corrosion resistance in the atmosphere and fresh water.
2. It has low melting point and is easy to be remelted, remelted and recycled. It has high strength, elasticity, hardness, fatigue strength, low elastic lag, corrosion resistance and wear resistance. Cold resistant, highly conductive, non-magnetic, impact free sparks are not easy to produce bite, good casting performance and cutting performance. A series of excellent physical, chemical and mechanical properties have good corrosion resistance in the atmosphere and fresh water. It is suitable for wearing parts working under high load (less than 20 MPa) and high sliding speed (8 m / s).
As we all know, copper slide plate has high hardness, good wear resistance, and it is not easy to produce the phenomenon of seizing, and it also has good casting performance and machinability. It has a strong corrosion resistance. So it is also very careful in the process of manufacturing, so what should we pay attention to in the process of manufacturing?
1: During casting, each process must be carefully handled. For example, the core must be placed in the right position when the box is closed, so as to avoid that the products cast cannot be processed according to the size due to this reason.
2: Before processing, first clean the casting, then get on the car, first correct it, then get off the car when processing to the semi-finished product, and cool it. Because copper has shrinkage, in order to process accurately, get on the car again when the workpiece is placed at room temperature for processing
3: After the finished product, especially if the straight sleeve cannot be placed horizontally, it shall be placed vertically to prevent deformation
4: The packaging shall be reserved to avoid deformation due to accidental collision during transportation.
|Quality assurance||2D Projector, Height Gague,Micrometer,Roughness Tester,
CCD Autimatic Testing Machine CCD,Callipers
Height and length:+/- 0.01mm.
Honors and certificates
Can we visit your facilities?
|Lead time||According to required time|