|Lubricant:||Oiling||Specification:||Full Sizes And Customized|
|Capacity:||OEM Or Making By Your Drawing||Processing Type:||Centrifugal Casting|
|Advantage:||Wear Resistant||Item:||Bronze Large Flange Bushing|
flanged sleeve bushing,
sintered bronze bushing
Non Standard Bronze Flanged Bushings High Presion Small Shrinkage Coefficient
Flange bushing, as the name implies, the bushing with flange outside, that is, flanged bushing, function: as far as the flange is concerned, it generally plays a role of positioning, not easy to fall off and slide.
Casting process of copper sleeve for horizontal flange of cone crusher.
As we all know, the horizontal flange copper sleeve of the cone crusher is also a kind of copper sleeve, so our casting method will adopt the centrifugal casting method, which can ensure the quality of the cast copper sleeve, avoid many sand holes and pores, and is an incomparable casting method for sand casting.
Crusher horizontal flange copper sleeve function.
1. Reduce the sliding friction of equipment during operation. Reduce power loss
2. The service life of the vulnerable parts of the cone crusher is greatly increased, the maintenance cost is reduced, and the utilization rate of the equipment is improved;
3. Effective protection, prevent steel parts from contacting with it, easy to replace when copper parts are worn.
The horizontal flange copper sleeve is installed in the inner end of the driving shaft of the cone crusher, one is close to the motor pulley, the other is close to the bevel gear, which bears a lot of pressure. Its material and size requirements are high, especially this is an important technical problem between the assembly and the transmission shaft. Due to the manufacturing and installation errors, it is easy to cause the horizontal flange copper sleeve to break, or even cause the powder to break, or the friction resistance is too large. The equipment is burnt or the drive shaft is damaged. Therefore, the selection of the material and size of the horizontal flange copper sleeve is the key to the normal operation of the equipment. The wear frequency of horizontal flange copper sleeve is very high
Testing equipment (manufacturer, Country of Origin)
UT,hardness inspection,Roughness inspectionChinese Brand
Address of production works (province, city)
|Southwest of Mazhuang Village, Yuhe Town, Huixian Xinxiang City Henan Prov.|
Can we visit your facilities?(Y/N)
|Short description of production process (for requested equipment)||Sand casting, metal casting, centrifugal casting, continuous casting, available|
|Quality control inspection||UT,hardness inspection,Roughness inspection|
Installation of copper bushing
The upper part of the moving cone copper sleeve is connected and fixed with the feed plate assembly by bolts, and the lower part is installed with the spherical bearing bush, which can be matched with the spherical steel bush installed in the sleeve; the outer part of the moving cone copper sleeve is installed with the moving cone liner made of copper alloy, and the gap between the moving cone and the liner is filled with epoxy resin; the inner part of the moving cone is installed with the upper and lower high lead bronze bushes.